[Prev][Next][Index][Thread]

Re: Ready to start new coil



Subject: 
           Re: Ready to start new coil
      Date: 
           Sat, 22 Mar 1997 09:11:06 EST
      From: 
           wb8jkr-at-juno-dot-com (Mark S Graalman)
        To: 
           tesla-at-pupman-dot-com
References: 
           1


On Sat, 22 Mar 1997 00:26:18 -0600 Tesla List <tesla-at-pupman-dot-com> writes:
>Subject: 
>           Re: Ready to start new coil
>      Date: 
>           Fri, 21 Mar 1997 09:11:52 PST
>      From: 
>           ulflyer-at-juno-dot-com (Stephen G Stanton)
>        To: 
>           tesla-at-pupman-dot-com
>References: 
>           1
>
>
>Hello all:
>
>Been lurking of late, but I'm now ready to start the Mark II version 
>of
>my coil.  I have the materials for the rolled cap(s), and the 6.5 inch
>PVC drain pipe for the secondary.  Going to use the RQ gap, and have 
>run
>the design parameters through Graalman's program; ready to roll.  
>It'll
>be powered by either my 12KV 60 ma neon, or may gang another 12 KV 30 
>ma
>on top; just over 1 KW.
>
>I need a good, inexpensive source for 18 or 20 gauge Formvar wire in 
>the
>N. Calif area preferably.   If surplus stores have this, I'm open to 
>800
>numbers and have VISA will travel.
>
>Thanks in advance.
>
>Stephen KJ6LH
>
>

   Hi Stephen,

 The source I use for magnet wire is:

    THE COAX CONNECTION
  Joe Cassata KA9CAI
 10S226 Meadow Lane
 Naperville, Ill. 60564


 Phone number: 1-708-420-0342

  He sells per pound any size from 30 ga. to 10 ga. from stock. 

  Good quality stuff, good prices.


                Mark Graalman WB8JKR