Re: Ready to start new coil

To: tesla-at-poodle.pupman-dot-com
Subject: Re: Ready to start new coil
From: Tesla List <tesla-at-stic-dot-net>
Date: Sat, 22 Mar 1997 00:26:18 -0600
Approved: tesla-at-stic-dot-net

Subject: 
           Re: Ready to start new coil
      Date: 
           Fri, 21 Mar 1997 09:11:52 PST
      From: 
           ulflyer-at-juno-dot-com (Stephen G Stanton)
        To: 
           tesla-at-pupman-dot-com
References: 
           1

Hello all:

Been lurking of late, but I'm now ready to start the Mark II version of
my coil.  I have the materials for the rolled cap(s), and the 6.5 inch
PVC drain pipe for the secondary.  Going to use the RQ gap, and have run
the design parameters through Graalman's program; ready to roll.  It'll
be powered by either my 12KV 60 ma neon, or may gang another 12 KV 30 ma
on top; just over 1 KW.

I need a good, inexpensive source for 18 or 20 gauge Formvar wire in the
N. Calif area preferably.   If surplus stores have this, I'm open to 800
numbers and have VISA will travel.

Thanks in advance.

Stephen KJ6LH