[Prev][Next][Index][Thread]
2 primary coils
I have 3 neons that are 15K at 30 ma and also 3 neons at are 12K at 30 ma. I am using the 15K neons connected in parralled for my TC. I would like to have some more power but can not connect the 12K neons in parallel with the 15K neons.
I have several primary coils and several secondary coils in my shop. I was wondering what would happen if I used what I already have to make 2 completely seperate power supplies to drive the same secondary coil.
I used one15K neons with a flat primary 6" ID by 30" OD 3/8" copper spaced 3/8" apart. I don't use this primary anymore because I have better luck with the helix wound primary. I used a Richard Quick spark gap 9 copper tubes in a 4" PVC pipe with a fan. One .008 uf rolled poly oil filled capacitor. Probably too much capaitance but I don't want to risk 2 neons in parallel just in case this does not work and it self distructs.
I used one 12K neon with a 30 degree helix primary 6" ID by 30" OD 3/8" copper spaced 3/8" apart. I used a Richard Quick spark gap 9 copper tubes in a 4" PVC pipe with a fan. One .008 uf rolled poly oil filled capacitor. Again too much capacitance but it is all I have.
I placed the helix primary on top of the flat primary with a 1" space between them at the center. I made sure the power supplies are in phase with each other so the primary would not arc to each other.
I used a 7" dia secondary 23" long wound with # 24 wire. The primaries were designed for a 4.5" secondary so I had to set the 7"secondary on top of the helix primary. The secondary wire was about 1/2" from the primary. I put a spacer under the secondary and lifted it up 3/4" more.
I attached the end of the secondary to the 4' long copper ground rod outside the shop and put a 10" diameter stainless steel bowl on top of the secondary for the toriod.
I turned it on and it is producing 33" arcs from the toroid. I ran it for only a short time. No problems so far.
Has anyone ever tried 2 power supplies and 2 primary coils on the same secondary before?
Gary Weaver