[Prev][Next][Index][Thread]
RE: Steinmetz Coil
----------
From: Tesla List[SMTP:tesla-at-poodle.pupman-dot-com]
Sent: Monday, October 14, 1996 1:25 AM
To: Tesla-list-subscribers-at-poodle.pupman-dot-com
Subject: Steinmetz Coil
>From rwall-at-ix-dot-netcom-dot-comSun Oct 13 22:28:45 1996
Date: Sun, 13 Oct 1996 18:49:20 -0700
From: Richard Wayne Wall <rwall-at-ix-dot-netcom-dot-com>
To: tesla-at-pupman-dot-com
Subject: Steinmetz Coil
10/13/96
Steinmetz invented a TC where the primary cap was replaced by an
inductor. This primary inductor directly drives the base of the
secondary and the secondary drives a magnifier. The power source is
direct current and there is a switch. Various schemes have been used
for the switch including multipactors. Would this be a good place to
try a hydrogen thyratron or would the cemf from the primary inductor
preclude this? Any ideas about a switching device?
Years ago I built a Kirillian photography generator with a variable
frequency solid state switch and an automobile coil. These coils are
very rugged and I never burned one out. Could a magnifier be driven
with one of these coils at the right frequency and power setting?
Big Questions: Why are we always so fascinated with switching the high
voltage side? Why not switch direct current, vary frequency and dwell,
limit current and quenching on the low voltage side of the power
transformer?
RWW
RWW,
I've had some identical thoughts in regards to Vacume tube coils. For
example, why not drive the cathode of a vacume tube rectifier with a high current
switching transitor. With the transitor base attached to an adjustable oscillator.
Yes I'm back from hell. Palm Springs was averaging 110 F last week.
D. Gowin
[Part 2, Application/MS-TNEF 3.1KB]
[Unable to print this part]