[Prev][Next][Index][Thread]

RE: TC Electrostatics




Could you try these series of measurements
with chicken wire, window screen, etc.,
interposed betwixt the coil and aluminum plate?
Barry

 ----------
|From: "tesla-at-poodle.pupman-dot-com"-at-PMDF-at-PAXMB1
|To: Benson Barry; "Tesla-list-subscribers-at-poodle.pupman-dot-com"-at-PMDF-at-PAXMB1
|Subject: TC Electrostatics
|Date: Monday, November 25, 1996 2:44AM
|
|<<File Attachment: 00000000.TXT>>
|From rwall-at-ix-dot-netcom-dot-comSun Nov 24 22:34:16 1996
|Date: Sun, 24 Nov 1996 19:40:18 -0800
|From: Richard Wayne Wall <rwall-at-ix-dot-netcom-dot-com>
|To: tesla-at-pupman-dot-com
|Subject: TC Electrostatics
|
|
|11/23/96
|
|The following are electrostatic voltages (kV) produced by a small TC
|and collected on a movable aluminum target.   A 14" x 14" flat aluminum
|sheet target was suspended vertically by the corners with  monofiliment
|line.  A 15 kV neon wire was attached to the back with tape and run to
|the ES voltmeter which was grounded to the system ground.  A fan was
|directed upward, blowing air between the TC terminal and Al target.
|
|The TC is 4" x 22" wound with #23 enameled wire and with a flat spiral
|primary.  The cap is 20 nF and there are two static tungsten gaps.
|Power by a 12/60 neon.  A 20" toroid was initially used, but a 1 1/2"
|brass ball was finally settled upon.
|
|After setting R (distance from ball trerminal to Al target) the TC was
|allowed to run until the voltage on the ES voltmeter stabilized.  Three
|series were done using R from 1' to 5' in each and input voltages from
|the variac of 50v, 60v and 70v.
|
|
|    R         50V       60V       70V
|
|    1'        8.25kV         8.6kV          9.9kV          
|    2'        4.4       4.6       4.75
|    3'             2.2       3.0       3.25
|    4'        1.7       2.2       2.35      
|    5'                  1.3       1.6       1.8
|
|Grafting R vs. voltage produces a linear plot with voltage proportional
|to 1/R, within experimental error.
|
|Conventional EM theory expresses an exponential decay proportional to
|1/R^2.  Conventional EM predicts about 79 volts for the 1.8 kV at 5'
|(70V column).
|
|Clearly, something in addition to EM is taking place in this system.
|Without doubt, electrostatics are involved and are produced by the TC.
|Are not scalar electromagnetics supposed to follow 1/R attenuation?
|
|RWW
|