Need Coiling Advice
Quoting Tom Renko <tahoetom-at-best-dot-com>
> I am building my second generation secondary coil. It is a
> six inch acrylic tube. I will be winding it with 22ga magnet
> wire. My question is this: Do I need to apply a layer of
> epoxy on the bare coil form before I begin winding? Any help
> would be appreciated............
I would just wind the wire on the clean bare coil form. There
is really no reason to "dope" the surface of the plastic prior
to winding on wire.
... If all else fails... Throw another megavolt across it!
___ Blue Wave/QWK v2.12
[ Glad to see you're back! -- Chip]