[Home][2015 Index] Re: [TCML] Grounding a rotation conductor [Date Prev][Date Next][Thread Prev][Thread Next][Date Index][Thread Index]

Re: [TCML] Grounding a rotation conductor



When I built a very large vdg for a science center I made sure the lower roller was grounded. The roller was set screwed onto a shaft that was supported on pillow block bearings which were grounded. Easy and effective.

 Doug <doug11642@xxxxxxxxxxx> wrote:

>The bottom rollers "BRUSH" "ONLY" needs to be connected to the discharge 
>wand! No other ground needed!
>
>On 9/15/2015 10:09 PM, Matthew Sweeney wrote:
>> I need to do so my lower roller, besides an actual brush setuo on oversize
>> washers ive found a part that uses liquid metal to do the job. Pricey tho.
>>
>> Any other ideas, maybe a couple spring washers fastened to ground with
>> enough tolerance to spin against the shaft washers (alternate to actual
>> brushes).
>>
>> Any ideas greatly appreciated :)
>> _______________________________________________
>> Tesla mailing list
>> Tesla@xxxxxxxxxx
>> http://www.pupman.com/mailman/listinfo/tesla
>
>_______________________________________________
>Tesla mailing list
>Tesla@xxxxxxxxxx
>http://www.pupman.com/mailman/listinfo/tesla
_______________________________________________
Tesla mailing list
Tesla@xxxxxxxxxx
http://www.pupman.com/mailman/listinfo/tesla