Re: [TCML] RE: Sound Modulated tesla Coils

[mddeming@xxxxxxx]

Paul Kidwell at  www.thegeekgroup.org has recently devised a way to play polyphonic music (up to eight voices) on a Tesla Coil. You might want to contact him. I think his email is: pkidwell@xxxxxxxxxxxxxxxxx Or, you can leave a message on the group website.

Matt D.


-----Original Message-----
From: Greg Cousen <lurch50@xxxxxxxxxxx>
To: 'Tesla Coil Mailing List' <tesla@xxxxxxxxxx>
Sent: Mon, Oct 22, 2012 5:24 pm
Subject: RE: [TCML] RE: Sound Modulated tesla Coils


Hi Mate,
Thank you for your reply, I have looked on the net but have not seen any
kits for the SSTCs, I have seen the rotary gap advertised as a kit, I will
keep on looking, here in Aust our voltage is 230 / 240 @50hz,
I will look into the variable frequency idea, thanks again :)

-----Original Message-----
From: tesla-bounces@xxxxxxxxxx [mailto:tesla-bounces@xxxxxxxxxx] On Behalf
Of Jim Lux
Sent: Monday, 22 October 2012 11:03 PM
To: Tesla Coil Mailing List
Subject: Re: [TCML] RE: Sound Modulated tesla Coils

On 10/22/12 1:24 AM, Greg Cousen wrote:
> Hi Everyone,
>
> Okay as new to this but totally wrapped in Teslas genius I am 
> experimenting with a few different things, info I need is where can I 
> get a diagram or schematic on how to build a musical tesla coil,
>
> Also I have a power supply that I use to run ladders etc; it is run 
> from the output of an isolation transformer with a variable auto 
> tranny on the secondary side wired for boost voltage, so instead of 
> 230vac I can get close to 300vac, can I run a coil from this, also I 
> have a ground earth setup totally isolated from mains ground earth 
> which seem to work well for other experiments I have done,


There are four ways, off hand, to get a TC that can play music.

1) for a static spark gap TC, the break rate (and hence the sound) is
controlled by the AC Line frequency.  You'll hear 120 Hz in the US, for
instance.  you could drive your transformer with a variable frequency
supply.  (there's a lot of tricky aspects to this..)

2) For a rotary gap TC, the break rate is controlled by the speed of the
rotor and the number of electrodes.  Change the speed of the rotor, and the
pitch changes. Or, figure out some way to select between rotors with
different numbers of electrodes (viz Hammond Tone Wheel organ)

3) A DC coil could be run with a triggered gap, and the trigger rate is
driven to control the pitch.

4) A solid state TC (SSTC) generates the HV pulses with hardware, and is
trivial to change pitch on.  I'd say that the vast majority of singing TCs
that you see on youtube, for instance, are SSTCs of one kind or 
another.   The problem with a SSTC is that it's more complex than a 
spark gap coil:  you have the high power transistors (IGBTs or FETs) and all
the drive electronics.  It's probably not a "assemble from your junkbox in a
few hours" like a NST powered spark gap coil might be.

There are people selling kits for DRSSTCs with music modulation inputs out
there.
_______________________________________________
Tesla mailing list
Tesla@xxxxxxxxxx
http://www.pupman.com/mailman/listinfo/tesla

_______________________________________________
Tesla mailing list
Tesla@xxxxxxxxxx
http://www.pupman.com/mailman/listinfo/tesla

 
_______________________________________________
Tesla mailing list
Tesla@xxxxxxxxxx
http://www.pupman.com/mailman/listinfo/tesla