[Date Prev][Date Next][Thread Prev][Thread Next][Date Index][Thread Index]

Re: [TCML] Primary Coil-sections



Hi Pete 
          I cramp one of my 1/4 copper tune enough so it would slip in the other
Tube and solder it together with silver solder.
Alton

Sent from my iPad

On Nov 16, 2012, at 12:28 AM, Pete Ritchie <petercritchie@xxxxxxxxx> wrote:

> Hi all, I have a quick question. I have been coiling for a few years now
> and havent really noticed too much  of an issue with this but i am just not
> sure of how it may effect the operation of a SGTC. The Primary coil
> consists of 1/4 inch copper tubing which is obviously common and my
> particular coil had to be made in two sections due to length availability.
> Now i have them connected via an amount of alumimun HVAC/ foil tape and
> continuity checks out and the output is decent. My question is, does
> anybody think that this may affect the primary inductance to a concernable
> amount? and might anyone know of a better method of connection for these
> sections of tubing? (soldering would not work) Thank you all for your
> time!  Sincerely Pete.
> _______________________________________________
> Tesla mailing list
> Tesla@xxxxxxxxxx
> http://www.pupman.com/mailman/listinfo/tesla
_______________________________________________
Tesla mailing list
Tesla@xxxxxxxxxx
http://www.pupman.com/mailman/listinfo/tesla