[Date Prev][Date Next][Thread Prev][Thread Next][Date Index][Thread Index]

Re: [TCML] Spark gap fan smoked



I have a NOS 20 amp EMI filter with 1/4" push on connector tabs listed on eBay, if anyone needs one. I'm only asking $12.95 or best offer. I'll be glad to accept lower offers from list members. Just mention that you are a member of the TCML when you make an offer. If you need more than one, I have another, too.
Paul
Think Positive

----- Original Message ----- From: "David Rieben" <drieben@xxxxxxxxxxx>
To: "Tesla Coil Mailing List" <tesla@xxxxxxxxxx>
Sent: Sunday, December 27, 2009 2:51 PM
Subject: Re: [TCML] Spark gap fan smoked


Hi Dennis,

As others have already mentioned, it is best to ground your
blower motor frame to the earth/mains ground. Another step
that I have taken in the past to solve the problem to which
you refer is to run the input leads to the motor through a
typical, properly rated EMI/RFI line filter.

David Rieben


----- Original Message ----- From: <otmaskin5@xxxxxxx>
To: <tesla@xxxxxxxxxx>
Sent: Sunday, December 27, 2009 9:09 AM
Subject: [TCML] Spark gap fan smoked



Hi, happy holidays everyone. For the first time in the 4 years since I built my first coil (15/60), I finally seem to have it running great without problems. Strikes to ground targets are reaching out into the low 50"s at a conservative 0.18" spark gap setting & variac driving it at no more than 120v (problem with the sweeper & it won't quite get to 120v). So I'm fairly pleased with the performance given I'm not pushing the coil too hard to do what it's doing. Best of all, I finally reached the point where I seem to have eliminated all the other issues like racing sparks & incessant safety gap firing. So that's the good part.

Then, yesterday I was just enjoying playing with the coil & watching the sparks when smoke started pouring out of the segmented spark gap. Looks like I burned up the 340 cfm 5" muffin fan for the spark gap...which brings me to my question. When wiring in the fan, I had only the hot & neutral wires going back to the mains, not the 3d prong ground. I had the chassis of the fan grounded to the NST case which is connected to the RF ground and a pipe driven into the ground outside of the garage. This is the second fan that I smoked and both were wired in the same fashion. I'm wondering whether I got it wrong relative to grounding the fan to the RF ground. - I thought this was a best practice, but maybe not. I'd welcome any suggestions. Thanks, Dennis Hopkinton MA
_______________________________________________
Tesla mailing list
Tesla@xxxxxxxxxx
http://www.pupman.com/mailman/listinfo/tesla
_______________________________________________
Tesla mailing list
Tesla@xxxxxxxxxx
http://www.pupman.com/mailman/listinfo/tesla

_______________________________________________
Tesla mailing list
Tesla@xxxxxxxxxx
http://www.pupman.com/mailman/listinfo/tesla