[Date Prev][Date Next][Thread Prev][Thread Next][Date Index][Thread Index]

[TCML] Re Electrode diameter



Hi All,
I'm building a 12" diam. secondary SRSG coil running at 10Kv, 7KVa, 50Hz and 100bps. Motor speed is 3000rpm, rotor 12" diam G10, two flying electrodes at 11" diameter and tank capacitance 0.15uF., I have a selection of Tungsten electrodes, both 1/4" and 1/2" diam and have a choice of either two or four fixed gaps in heavy brass. Is 1/4" diam adequate to contain the heat or is 1/2" better perhaps to aid regular firing albeit increasing the dwell. Should the electrode gaps be minimal ( without risk of contact of course) or is there an optimum distance, again to slightly reduce the dwell time. I appreciate that the relatively low input voltage limits experimentation in this last regard,
Any help greatly appreciated,
Regards,
Phillip.
_______________________________________________
Tesla mailing list
Tesla@xxxxxxxxxxxxxx
http://www.pupman.com/mailman/listinfo/tesla