[Date Prev][Date Next][Thread Prev][Thread Next][Date Index][Thread Index]

Re: MOSFET TC design



Original poster: "GEORGE STEIN" <afa2fg@xxxxxxx>

Does anyone have plans for a small table top, twin coil setup that could use these toroids?? I wouldn't mind building one to put in my office...

George Stein
Bedford, Va.


From: "Tesla list" <tesla@xxxxxxxxxx>
To: tesla@xxxxxxxxxx
Subject: Re: MOSFET TC design
Date: Wed, 18 Oct 2006 20:49:09 -0600

Original poster: FutureT@xxxxxxx

In a message dated 10/18/06 8:44:44 PM Eastern Daylight Time, tesla@xxxxxxxxxx writes:

I also still have some 1.75" x 6" spun toroids available for $43 each
which might work well on the coil.

John
---

I expect spark output using a 1 x 7 inch toroid to be approx 16 - 18
inches long.  Not bad for a complete system weighing less than 6
lbs.!  I'm having O.W. run a batch of toroids for me.  The more
orders the cheaper the toroids will be for everyone.

Anyone that might be interested in a board please advise as I plan on
placing the board order early in November.  Contact me off-list and
advise.  I will add you to our board bulk purchase list.

Also, contact me off-list and I will email you the pri-sec coil
geometry plans so you can start working on gathering your parts.  PVC
tube, wire, phenolic plates, etc.

Happy long sparks!

Dr. Resonance