[Date Prev][Date Next][Thread Prev][Thread Next][Date Index][Thread Index]

Re: Rolled cap hell



Original poster: "robert heidlebaugh" <rheidlebaugh-at-desertgate-dot-com> 

Andrew: give up the 3" pipe you will never make it.  I use a heat sealer to
mount my plates in a plastic bag to keep them spaced properly. Your 6 mill
will work quite well. cut your 6 mill to the highth of your plates plus 2
inches. place one plate on your plastic  at the top and roll the plate
around the sides with 16 layers then place a plate below and on top at the
bottem edge and roll  16 more layers. That will give you one plate at the
top and 2 plates at the bottem  seperated with 16 layers of plastic . Now
put a plate under and a plate on top at the top and roll another 16 layers
of plastic. repeat at the bottem layer after layer. I use 10 plates and wind
another capacitor  I use 4 capacitors in parallel to get my total
capacitance. If each section is to thick you will not be able to make
connection to all the plates. I use pop rivets with aluminum washers as
spacers between each plate at each end with flat strap connections. My stack
is about 8 " x 12" x 5 " in size That in a plastec container of oil. My
students use smaller plates and assembel them in coco cans in parallel.
rolling the plastic around the sides of the plates keeps every thing in
place. After each section is rolled I tie each cap section with Nylon string
before final assembly.
      Robert   H
-- 


 > From: "Tesla list" <tesla-at-pupman-dot-com>
 > Date: Fri, 22 Oct 2004 21:15:20 -0600
 > To: tesla-at-pupman-dot-com
 > Subject: Rolled cap hell
 > Resent-From: tesla-at-pupman-dot-com
 > Resent-Date: Fri, 22 Oct 2004 21:20:45 -0600
 >
 > Original poster: "Andrew Genseal" <aggniu-at-hotmail-dot-com>
 >
 > well, I attempted to roll my first cap tonight.  It was quite the
 > disapointment.  I have 6mil poly, and I am using the "sandwich" method (2
 > sandwiches with plates wrapped in 8 pieces of 66" long by 14" wide
 > poly).  The cap I am going for is roughly 003uF using 29" or 10" wide roof
 > flashing for the plates (BTW, it is a simple 2 plate cap).  The enclosure
 > of choice is a 3" pvc pipe.  My biggest question is what is the best way to
 > go about rolling these things up real tight? As a person who has never
 > attempted this before, I approached this thing thinking it would be
 > easy.....boy, was I wrong.  Is there any way of binding the sheets
 > temporarily to wind it, then removing such a device?
 >
 >