[Date Prev][Date Next][Thread Prev][Thread Next][Date Index][Thread Index]

RE: circuit board makers



Original poster: "Mccauley, Daniel H by way of Terry Fritz <twftesla-at-qwest-dot-net>" <daniel.h.mccauley-at-lmco-dot-com>



Just remember, FR-4 dust, is extremely hazardous to breath in.  Not as
hazardous as say beryllium dust, but none the less,
you should wear a dust mask when machining this material.

Dan




Contact www.4pcb-dot-com and tell them The Geek Group sent you :)

Or, get a Dremel and whip up a simple jig and you're set.