Re: Batch of Synchronous Motors - Nice 1/4" Hub

["Tesla list" <tesla-at-pupman-dot-com>]

Original poster: "by way of Terry Fritz <twftesla-at-qwest-dot-net>" <tb3-at-att-dot-net>

He told me the shaft is 5/16th inch.


> Original poster: "Daniel McCauley by way of Terry Fritz
<twftesla-at-qwest-dot-net>" 
> <dhmccauley-at-spacecatlighting-dot-com>
> 
> Regarding D.C. Cox's Synch Motors he is selling:
> 
> I haven't heard the final on whether the shaft size is 1/4" or 5/16"
> (hopefully 1/4"), but
> i found a wonderful 1/4" hub which could be used in conjuction with this and
> a rotor.
> 
> Jameco Electronics is selling it for about $4.90
> 
> https://www.jameco-dot-com/Jameco/Products/ProdCT/p172.pdf
> 
> 
> I guess even if his motors are 5/16" shaft diameter, you could machine the
> hole an extra 1/16" without damaing the hub.
> 
> 
> Dan
> 
> 
> 
> 
>