Re: Cutting PVC

["Tesla list" <tesla-at-pupman-dot-com>]

Original poster: "by way of Terry Fritz <twftesla-at-uswest-dot-net>" <Parpp807-at-aol-dot-com>

In a message dated 3/9/01 5:49:26 PM Central Standard Time, tesla-at-pupman-dot-com 
writes:

<< Also, if you are using a table saw,
 "roll" the tubing into
 the blade while keeping the tube against the T square.
 
 Scot D >>

Easy there. The part about holding the tubing against the T- square or 
against anything
can often bind the saw. Not good. I find it difficult to roll the tube into 
the saw blade while
holding the tube perpendicular to the saw. It works best on small diameter 
tubing.
Gotta be careful not to bind the saw blade.

Cheers,
Ralph Zekelman