[Date Prev][Date Next][Thread Prev][Thread Next][Date Index][Thread Index]

Rotary Gap Motors/Parts- Ifno???



Original poster: "raven0075 by way of Terry Fritz <twftesla-at-uswest-dot-net>" <raven0075-at-home-dot-com>

Parts for the shaft.
Phenolic Disk, where can I get these or can I use a grinding disk blade?? and
modify it.
 
Metal hubs for the motor shafts. any good websites to get these parts at?
 
Here are the following motors I have for my choices for my rotary Gap, state
and military surplus.
 
IMC magnetics Corp. military surplus.
230v 1ph 60hz, 3.5/1.2A  .73/.12HP 3450/1725 RPM, 5/8 input shaft, Thermal
protected. I think this one will be overkill (Really Heavy duty).
    
Franklin Electric
110v 1ph 1/3hp FLA 5.6 RPM 1725.no thermal protection, 3/8input shaft.  I think
this one is overkill.
                            FLA??? does this stand for amps??
These two seam to be for heavy duty use.
 
 (I think I want to use this one) military used.
115v 60hz  1ph 1.5amp 3400rpm, its dimimensions are 3 1/2 by 3 1/2, 1/4 input
shaft.
 
4. I also have some small fan motors, 
115v 9w .82amp 60hz, 1450RPM, these are probly to small for rotary use on a
larger coil.
 
I will be getting a 10amp VARIAC to use with wichever one I select. (I know
10amp is overkill, but you never know what else you might have to use is for)
 
I have some extra surplus I might want to sell, the motors listed above the
Franklin Elelectrics are new, never used state surplus have about 8, I will
post the prices and photo's to my website in a couple of days, if anyone might
be interested.
 
Well all suggestions will be appreciated.
 
Thanks
Brian W.