MOT

[Hhchicken1-at-aol-dot-com (by way of Terry Fritz <twftesla-at-uswest-dot-net>)]

Hello list!
My MOT has three windings on it - one for 240v mains, one HV winding and also 
one with about 10 turns which I assume to be low voltage, but extremely high 
current - filament for magnetron?
If I plugged 240vac into this third winding, and drew HV out from either the 
primary or HV secondary, do you think the MOT would fry?  If not, this would 
presumably give a very high voltage and low current output, which is 
considerably safer than the 2000V, ~1A output given in its usual 
configuration.

Thanks in advance for any advice,
    Henry Hall