[Prev][Next][Index][Thread]

Re: Toroid evelation and E-Tesla5



Hi Marco,

At 10:15 AM 5/26/00 +0300, you wrote:
>Hi all.
>
>Terry, I used your E-Tesla5 to check the toroid elevation and I think I
>understood what would be the best position for a second toroid (smaller).
>
>But, please, allow me a couple of stupid questions (I haven't had time to
>re-read my old theory books):
>
>- is the Voutput file intented to be a volt/meter (scaled) plot? Is that the
>electric field?

Yes,  If you know your terminal voltage you can input that and then the
E-fields will be accurate in relation to the coil size.  It outputs the
real voltage on the grid.  You may have to divide that number by the room
size to get the true volts/meter.  I will look into that...

>- is the Soutput a derivate of the above (i.e. electric field density)? Is
that
>a (scaled) measure of the electric flux?

I simply fine the voltage "difference" between grid points from the above.

>- I have been trying to minimize spots around the secondary winding top in the
>Soutput and to achieve higher values around the top toroid: is that the
correct
>procedure?

The Soutput.xls file shows high field stress points.  You need to look at
that and try to minimize the stress at the top winding of the secondary.  A
toroid tends to arc a little above its centerline on the outside in any case.

>
>Regards
>
>