Re: NST Protection

• To: tesla-at-pupman-dot-com
• Subject: Re: NST Protection
• From: Esondrmn-at-aol-dot-com (by way of Terry Fritz <twftesla-at-uswest-dot-net>)
• Date: Wed, 17 May 2000 11:35:42 -0600
• Approved: twftesla-at-uswest-dot-net
• Delivered-To: fixup-tesla-at-pupman-dot-com-at-fixme

In a message dated 5/15/00 11:02:33 PM Pacific Daylight Time, 
tesla-at-pupman-dot-com writes:

<< 
 Hi all,
        I'm in the process of building my NST protection for a 15kv/30ma 
setup.
 I have 2 safety gaps + 2  500pf 30kv caps to ground. I am wondering as to 
what
 rating to go for in the way of resistors. I have seen a few different setups 
on
 some of your web sites but most are for larger NST's. Should I go for
 1.5k/100watt, one on each HV side?
 1k/50watt,two on each side?
 5k/50watt,two on each side?
 And could someone please explain what is the correct way to work out the 
right
 resistors for a particular power supply.
                  thanks in advance,
                                               Arthur.
 
  >>
Arthur,

I use 3,000 ohm, 25 watt resistors on my 12 kv 60 ma coil.  Secondary is 3.0" 
diameter. Makes 26" sparks.

Ed Sonderman

• Prev: Re: New solid state pictures
• Next: Re: Solid versus stranded Wire
• Index(es):
  • Main
  • Thread