Re: A new tuning idea?

["Mark Broker" <broker-at-uwplatt.edu> (by way of Terry Fritz <twftesla-at-uswest-dot-net>)]

Gary,

This is true, but since I'm using a 120 BPS SRSG, would not the meter show the
RMS value of the 120BPS pulses?  Since the measurement takes about 5 seconds to
setup, and another 5 seconds to take, I'll try it anyway.  If I get anything
useful, I'll post it here.

Mark


Tesla list wrote:

> Original poster: "Lau, Gary" <Gary.Lau-at-compaq-dot-com>
>
> These clamp-on meters were designed for 60 Hz use only.  I very much doubt
> they would give any response at 100-200KHz at all.
>
> Gary Lau
> Waltham, MA USA
>
> Original poster: "Mark Broker" <broker-at-uwplatt.edu>
>
> Steve and list,
>
> While tuning my own coil, I used a friend's clamp-on anolog AC ammeter that
> operates the same way as is described below.  These can be purchased at
> hardware
> stores for very little money.  I believe I ran across one at a True Value
> for
> about $40-50.  And it's good from 6 to 300A (the max settings).
>

<snip>