Re: Secondary question!

["Tesla list" <tesla-at-pupman-dot-com>]

Original poster: "by way of Terry Fritz <twftesla-at-uswest-dot-net>" <Esondrmn-at-aol-dot-com>

In a message dated 12/18/00 10:43:38 AM Pacific Standard Time, 
tesla-at-pupman-dot-com writes:

<< 
  
 HI all,
 I have looked for a coil to use as a model and I have found some that I'll
 think would be just perfect.
 But many of them uses AWG 28 magnet wire, and the only AWG I can get in that
 "size" is AWG 28 and 29. I have relized that I will use more power about 630W
 and I want to build it as good as I can. The two secondaries I will chose 
from
 will probably be:
  
 1) Secondary 4.5"x20"
 AWG 29
 Inductance 61mH
 Turns ~1630
  
 would the wire hold?
  
 2) Secondary 4.5"x23"
 AWG 27
 Inductance 45mH
 Turns ~1500
  
 Which one would you experienced coilers choose? Or If you got other 
suggestions
 please tell me.
 (Forgive my ignorance)
  
 Thank You!
  
 Michael / Sweden >>

Michael,

Either secondary should perform just fine.  I doubt you would notice any 
difference between the two.  I would probably go with the #27 wire as it will 
be a little easier to work with.

Ed Sonderman