[Date Prev][Date Next][Thread Prev][Thread Next][Date Index][Thread Index]

Re: Sparkles in the arcs



Hey everyone,
What I photographed is a bit more than your everyday average "sparkles in
the arcs", but I doubt it would work with a full sized TC.
Check out the link below. You can decide for yourselves what is happening
here...
http://members.xoom-dot-com/mpn54601/candlearc1.jpg
On the left is a screwdriver which conveys about 10kV 2-3mA -at- 20KHz into the
heart of the flame. Right: a ground wire held approx. 1cm from edge of
flame. Center: ???!!!
Plasmoid maybe?
Safe coiling,

    -Michael


----- Original Message -----
From: Tesla list <tesla-at-pupman-dot-com>
To: <tesla-at-pupman-dot-com>
Sent: Monday, August 28, 2000 9:31 PM
Subject: RE: Sparkles in the arcs


> Original poster: "Richard Barton" <richardbarton-at-caving5.freeserve.co.uk>
>
> Hi
> As a diversion, balance on the top of the toroid, a little candle
> night-light, the sort with an aluminium cup around it. Light it, and
switch
> on (And NOT vice-versa !), and watch a arc coming from the flame
> itself ! The flame gets a battering, and splutters, but I've not had it go
> out.
> Richard Barton.
>
>
> -----Original Message-----
> From: Tesla list [mailto:tesla-at-pupman-dot-com]
> Sent: Monday, August 28, 2000 6:33 PM
> To: tesla-at-pupman-dot-com
> Subject: Re: Sparkles in the arcs
>
>
> Original poster: "Bert Hickman" <bert.hickman-at-aquila-dot-com>
>
> Tesla list wrote:
> >
> > Original poster: "Ross Overstreet" <ross-o-at-mindspring-dot-com>
> >
> > Hi,
> > I was playing around with building fires on top of my toroid this
weekend
> > when I stumbled across an interesting effect.  Burning cardboard
> apparently
> > liberates lots of carbon particles that make bright sparkles in the
brush
> > discharge of a TC running at low power levels.  My photo didn't turn out
> too
> > well, but you can get a rough idea of what I was seeing in the top photo
> on
> > my "arc pictures" page.
> > http://users.better-dot-org/roverstreet/Arc_pics/arcpics.html
> >
> > I bet the effect would be really spectacular if you get a lot more
carbon
> > (or whatever made the sparkles) into the air around the toroid.  To
repeat
> > this, all you have to do is light the cardboard and place it on the edge
> of
> > the toroid.  Once it develops a small burned spot it will act as a
corona
> > point.  It works best on the leeward side of the toroid.  Don't burn the
> > house (or woods) down.
> >
> > Seeya,
> > Ross-O
> > http://users.better-dot-org/roverstreet/index.htm
>
> Ross,
>
> VERY interesting!! These look very similar to the "ball lightning" that
> the Corums photographed off their system. Carbon particles are the
> likely cause... and there's speculation that similar particles generated
> the ball lightning that Tesla observed in his system when he had
> secondary flashovers on his systems (with carbon-producing cotton or
> gutta-percha (rubber) insulation). Do any of the sparkles last very
> long?
>
> -- Bert --
>
> --
> Bert Hickman
> Stoneridge Engineering
> Email:    bert.hickman-at-aquila-dot-com
> Web Site: http://www.teslamania-dot-com
>
>
>
>
>
>
>