[Date Prev][Date Next][Thread Prev][Thread Next][Date Index][Thread Index]

Re: New Gap Idea



Sam,
Not a very good thing to try. at high power, the arc would heat the
material, leaving carbon tracks, thus making it conductive. I've seen a
similar design that uses aluminum and copper plates with threaded nylon rod.
The only reason that worked good is, the copper was used as the sparking
surface, and the aluminum, which the threaded rod ran through, was used as
heatsinking.
Although I've had good success with multiple static gaps, there are still
only two good choices:
Air Blast and SRSG.
Static gaps just don't have a very good quenching rate. And, because they
are fixed, the heat stays around and messes with breakdown voltage and
whatnot.
Back to the drawing board...

    -Michael



----- Original Message -----
From: Tesla list <tesla-at-pupman-dot-com>
To: <tesla-at-pupman-dot-com>
Sent: Monday, August 21, 2000 12:33 PM
Subject: New Gap Idea


> Original poster: "Sam Beck" <Sam-at-peterbeck-dot-com>
>
> Hey, how about this static gap design...picture a long threaded rod
> of, say, some sort of plastic.  Now you start at the bottom with a bolt,
> and add a brass washer of rather large diameter.  On top of that you add a
> plastic(or mica maybe) washer of small diameter, and just repeat.  You
> terminate with a bolt and attach to your tank circuit from the ends...
> Feedback, anyone?
>
> Sam Beck
>
>
>
>
>