Re: Best Secondary Surface coating

• To: "'Tesla List'" <tesla-at-poodle.pupman-dot-com>
• Subject: Re: Best Secondary Surface coating
• From: Tesla List <tesla-at-stic-dot-net>
• Date: Wed, 19 Nov 1997 22:58:25 -0600
• Approved: tesla-at-stic-dot-net

From: 	Engle, Daniel (NJAOST)[SMTP:DEngle-at-NJAOST.ML-dot-com]
Sent: 	Wednesday, November 19, 1997 8:48 AM
To: 	'Tesla List'
Subject: 	RE: Best Secondary Surface coating

Another question, has anyone tried spray-on latex or rubberized paint,
some kind of insulating paint?  


> From: 	Mad Coiler[SMTP:tesla_coiler-at-hotmail-dot-com]
> Sent: 	Tuesday, November 18, 1997 5:01 PM
> To: 	tesla-at-pupman-dot-com
> Subject: 	Re: Best Secondary Surface coating
> 
> List,
> 
> I am in the process of putting together a new coil and was planning on
> 
> using polyurethane to coat the secondary. Is this a good coating 
> material or not? I was planning on coating a portion of the sec form
> and 
> then winding the wire over the wet coat of poly. Then I could coat
> over 
> the top. Another main factor in this is cost (like ~$0). I already
> have 
> lots of polyurethane from doing woodworking. Comments on polyurethane
> as 
> a secondary coating?
> 
> Tristan Stewart
> 
> 

• Prev: Re: RE- Dielectric Constants and Breakdown Voltages (fwd)
• Next: Re: Best Secondary Surface coating
• Index(es):
  • Main
  • Thread