RE: Foil Caps (was Cap Pr (fwd)

• To: tesla-at-pupman-dot-com
• Subject: RE: Foil Caps (was Cap Pr (fwd)
• From: Tesla List <mod1-at-pupman-dot-com>
• Date: Mon, 3 Mar 1997 22:00:03 -0700 (MST)
• Approved: mod1-at-poodle.pupman-dot-com

---------- Forwarded message ----------
Date: Tue, 4 Mar 1997 09:06:24 +1200
From: Malcolm Watts <MALCOLM-at-directorate.wnp.ac.nz>
To: tesla-at-pupman-dot-com
Subject: RE: Foil Caps (was Cap Pr (fwd)

Ken,
     I bought the 0.25mm clear polyethylene I use for rolled caps from 
Langs h'ware in Wellington (NZ). The last time, I bought an entire 
roll of pristine stuff. They had put it to one side thinking the talc
powder on it was some kind of defect. I snapped it up.  As a bonus, it 
had fewer defects than any other I had previously bought.
     It might be worth seeing if you can get sheet polypropylene from 
somewhere. The stuff is prolific - they make those budget deck chairs 
out of it. It has a much higher m.p. than polyeth. I'd love to get my 
hands on a roll if anybody in N.Z. knows where to obtain it.

Malcolm

> T>Now here is a problem.  Two plastic sheetings.  Both the same thickness
> T>(builders yard stuff).  One black one clear(ish) The clear is 3 times the
> T>cost of the black.  What is the difference ?
> 
> T>Can I use the black sheeting for a cap ?  If the answer is no, I have wasted
> T>a morning <Aggggh>
> 
> T>Ken Smith
> T>Auckland

• Prev: RE: Discharge Terminals (fwd)
• Next: Moderator hand off (ADMIN) (fwd)
• Index(es):
  • Main
  • Thread