Re: Dumpster diving, tube cutting

• To: tesla-at-pupman-dot-com
• Subject: Re: Dumpster diving, tube cutting
• From: SSNSanders-at-aol-dot-com
• Date: Fri, 22 Nov 1996 10:23:17 -0500

In a message dated 96-11-22 00:37:41 EST, you write:

<< 
 I recently obtained a 9.5" OD PVC pipe (heavy wall) that I was thinking 
 of making into a coil form.  The problem that I face is cutting the thing 
 off squarely.  Does anyone have any tips?  At this point I think the best 
 course of action is to mark it carefully and use a hand saw.
 
 
 Chip >>
Rotate it as it rests in a piece of angle iron to mark it squarely an then
cut it with a dremmel tool cutting wheel, works good.   Steve

• Prev: Re: Sparks to ground
• Next: Re: Dumpster diving, tube cutting
• Index(es):
  • Main
  • Thread